To Replace a Lost Filling:
Wash the cavity area with warm water.
Scoop a small amount of DenTek Temparin from the vial, and roll into a ball between fingers. Slightly overfill the cavity with DenTek Temparin and tap into place with the provided cotton swab moistened in water.
Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite.
Use the cotton swab to remove excess Temparin from around the area.
Moisture will accelerate the set.
DenTek Temparin will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to set.
To Replace Loose Crowns, Caps or Inlays:
Try the crown, cap or inlay first to see if you can fit it accurately back onto the tooth surface.
If you are not able to do so, then do not proceed further.
If the crown has a post attached to it or if there is tooth surface remaining inside the crown, DenTek Temparin may not adhere.
Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry.
Scoop a small amount of DenTek Temparin from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay.
Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position.
DenTek Temparin will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set.
Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.
To avoid infection and/or serious injury, this product should not be used if there is throbbing pain, ulceration or swelling in the affected area.
If any of these symptoms exist, consult your dentist immediately. This product should not be placed on open wounds.
Wash and dry your hands.
Use only what is needed to repair the dental emergency, and save the rest for a future application.
Keep our of reach of children.
Read instructions carefully.